Toshiba VP 300 Installation Instructions Manual page 255

The hard disk drive assemblies are sensitive to static electricity. Do not attempt the
following procedures without wearing an anti-static wrist strap.
Removing Hard To remove the HD, follow the procedures described below.
Disk Drive
1. Unlock and open the door of the cabinet.
2. Put on antistatic wrist strap. Connect it to an unpainted portion of the
3. Locate the drive assembly to be removed.
4. Using a flat-blade screwdriver, unscrew the two captive screws that secure
5. Gripping the front flange, pull the drive assembly out, use your free hand to
6. Carefully place the drive assembly nearby to be reinstalled or shipped.
Installing Hard To replace the hard disk drive, follow the procedures described below.
Disk Drive
1. Put on antistatic wrist strap. Connect it to an unpainted portion of the
2. Remove the new disk drive from the shipping container.
3. Verify that the part number on the label attached to the sheetmetal plate of
N WARNING N
cabinet.
the hard disk drive to the cabinet.
support the bottom of the drive when it clears the cabinet.
N WARNING N
The hard disk drive assemblies are sensitive to rough handling.
Care should be taken to handle them as gently as possible.
Disk drive ID will automatically be selected when the drive assembly is
installed. Do not change jumpers on the disk drive.
cabinet.
the disk drive assembly agrees with what has been ordered (see table).
MAINTENANCE
Toshiba VP Systems Release 7.1 July, 1994
5-97