Toshiba VP 300 Installation Instructions Manual page 579

CALLER: TXXX
XXX is the trunk number.
If the display does not contain this information, determine the cause and correct the
problem before continuing.
K. Press the EXIT softkey on the Superset 4. Hang up phone A. Change phone B's Call
Rerouting Always Alternative back to No Reroute for all types of calling devices.
11. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT)
(For new installation only)
This test verifies that each VP 300 port extension can transfer a call to the intercept
extension (attendant).
A. Connect the Superset 4 phone to the 25-pair cable of the PBX extension used for the
first MIC port.
B. Wait for the PBX to initialize the Superset 4. This may take as long as 30 seconds.
Once the set is initialized, the display should show the time and date. If the display
does not show the time and date within 30 seconds of connecting the phone, correct the
problem before continuing. If the display contains information other than the time and
date, lifting the Superset handset off-hook and replacing it may correct the problem.
C. From phone A, call the extension number of the Superset.
D. Answer the Superset. Transfer phone A to the attendant by pressing the TRANS/CONF
softkey, dialing 0, and pressing the HANG UP softkey. Does phone A get connected
to the attendant?
➧
NO
E. Connect the Superset to the 25-pair cable of the next MIC port extension and make
sure the phone initializes and displays the time and date. Repeat steps B through D for
each MIC port until every MIC port has successfully transferred a call to the attendant.
The PBX testing is now complete. Proceed with installation of the MIC board(s).
I
Installation of the MIC Board
This section describes the procedure for installing the MIC board (VP-4PMIC). Reconnect the
25-pair cable to the VP 300. Before proceeding with installation, note that there are six LEDs
on the front edge of the MIC, near the top of the card. These are used to indicate card status and
are, from top to bottom:
MITEL SX-2000 ADAPTIVE INTEGRATION
Determine the cause and correct the problem before continuing.
Toshiba VP Systems Release 6.1 February, 1993
10.3-37