Hard Disk Add For Release 6.1 And Later - Toshiba VP 300 Installation Instructions Manual

6-76 Installation and Maintenance Manual
I Hard Disk Add for Release 6.1 and Later
This section provides the procedures to follow when adding a drive to a system. Adding a drive to a
system is usually done to increase system storage or to add the optional redundancy feature.
Action
Install the Drive(s)
1. Forward ports.
Boot the System
2. Make sure Software
Diskette #1 (at the
correct release level) is
write-protected.
3. Insert Software Diskette
#1 (at the correct release
level) into the FD.
4. Adjust the baud rate of
the terminal/teleprinter to
300, 1200, or 9600 baud.
5. Press the Reload button
to boot from floppy
diskette. With the
teleprinter baud rate
set, press
Toshiba VP Systems Release 7.1 July, 1994
When doing the Hard Disk Add procedures, make sure that the diskettes being used are for
the correct release level.
VP 300 Description and Response
The following messages are printed:
twice.
Enter
CPU
. . . .. 05MB . . . . . . . . . . 1200 BAUD MODEM . . . . . .
BOOTING FROM FLOPPY DISK
. . XBOOT . . .
- - - - - - - - SYSTEM SOFTWARE RELEASE X.X.X.X (MM/DD/YY) - - - - - - - -
DAY MM/DD HH:MM:SS YYYY ID:000 S/N:00000 PBX: 00
(MODEM ENABLED) LAST LOGON: MM/DD HH:MM
@WAITING FOR VCU READY
LOADING VCU WITH FILE F:VCU
VCU STARTED
SYSTEM INITIALIZATION SUSPENDED!
PASSWORD:
@
Model 300-6004-101 Rev A1