Toshiba VP 300 Installation Instructions Manual page 362

6-48 Installation and Maintenance Manual
Configured
I
DISKO
The DISKO utility, available on the VP 300 Software Diskette, prepares the system for:
•
•
•
•
•
DISKO is accessible only after booting the VP 300 from the Software Diskette. It cannot be run
from the hard disk.
@DISKO
Slot
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1. ADD DISK
2. REMOVE DISK
3. REPLACE A DISK
4. RESTORE SYSTEM
5. UPGRADE LANGUAGES
Select option to be performed
:
Toshiba VP Systems Release 7.1 July, 1994
Identifies the drive as one the following:
Configured
Not Configured — Drive is not being utilized as its position is greater than the
Adding a disk.
Removing a disk.
Replacing a disk.
Restoring a disk.
Upgrading languages (Rel 6.1 or later).
CURRENT STATUS
Type ID Status
B3 System1 S1 ACTIVE
B4 System2 S2 ACTIVE
C1 Voice1 – – EMPTY
C2 Voice2 – – EMPTY
C3 Voice3 – – EMPTY
C4 Voice4 – – EMPTY
DISK OPTIONS
(1–5, – Empty line = EXIT)
5. UPGRADE LANGUAGES field is shown only with systems installed with Release 7.1
or later.
— Drive is within the number of drives currently configured.
number of drives currently configured.
Configured
Configured
Configured
Not Configured
Not Configured
Not Configured
Not Configured