Polycom RMX 1500 Administrator's Manual page 495

• In version 7.2, when configuring Multiple Networks on the RMX 2000,
the RMX2000_RTM_LAN flag must be set to YES in addition to the
MULTIPLE_NETWORKS=YES flag
• This option is supported with MPM+ and MPMx media cards.
• Multiple Network Services are supported in MCUs with at least
1024MB memory only. MCU units with memory of 512MB support
only one IP Network Service.
• Multiple Network Services are NOT supported with Microsoft ICE
Environments.
• Only IPv4 is supported for the definition of Multiple Network
Services.
• On RMX 1500, up
associated with each Media card.
On RMX 2000/4000, a media card can be associated with only one
Network Service.
• On RMX 2000/4000, RTM ISDN or RTM LAN can be used for
Multiple Services configuration.
• On RMX 1500, when Multiple Network Services option is enabled,
the two networks must differ in their subnet masks.
• On the RMX 1500, LAN redundancy cannot be enabled in parallel to
Multiple Networks and the LAN_REDUNDANCY flag must be set
to NO when the Multiple Networks option is enabled.
• An IP Network Service can be associated with one or several media
cards.
• If more than one card is associated with the same Network Service,
the system routes the calls to the appropriate card according to
resource availability
• Participants on different networks can connect to the same
conference with full audio, video and content capabilities.
• Traffic on one network does not influence or affect the traffic on other
networks connected to the same MCU, unless they are connected to
the same media card. If one network fails, it will not affect the traffic
in the other connected networks, unless they are connected to the
same media card and the card fails.
to two Network Services, one per LAN port, can be
Chapter 14-Network Services
14-61