Polycom RMX 1500 Administrator's Manual page 488

Polycom RMX 1500/2000/4000 Getting Started Guide
14-54
10 Define the following parameters:
Table 14-23 Phones Settings
Field
First Number
Last Number
•
A range must include at least two dial-in numbers.
• A range cannot exceed 1000 numbers.
11 Click OK.
The new range is added to the Dial-in Phone Numbers table.
12 Optional. Repeat steps 8 to 10 to define additional dial-in ranges.
13 Enter the MCU CLI (Calling Line Identification).
In a dial-in connections, the MCU CLI indicates the MCU's number
dialed by the participant. In a dial-out connection, indicates the MCU
(CLI) number as seen by the participant
14 Click Save & Continue.
After clicking Save & Continue, you cannot use the Back button to
return to previous configuration dialog boxes.
The ISDN/PSTN Network Service is created and confirmed.
15 Click OK to continue the configuration.
The Spans dialog box opens displaying the following read-only fields:
— ID – The connector on the ISDN/PSTN card (PRI1 - PRI12).
— Slot – The media card that the ISDN/PSTN card is connected to
(1 or 2)
— Service – The Network Service to which the span is assigned, or
blank if the span is not assigned to a Network Service
— Clock Source – Indicates whether the span acts as a clock source,
and if it does, whether it acts as a Primary or Backup clock
source. The first span to synchronize becomes the primary clock
source.
— State – The type of alarm: No alarm, yellow alarm or red alarm.
Description
The first number in the phone number range.
The last number in the phone number range.