Hardware Monitor Indications - Polycom RMX 1500 Administrator's Manual

Polycom RMX 1500/2000/4000 Getting Started Guide

Hardware Monitor Indications

14-42
3
On the RMX 2000, in the Setup> System Configuration > System
Flags dialog box, add the flag RMX2000_RTM_LAN and set it to YES
to activate the installed RTM LAN card
— On RMX 2000/4000, LAN Redundancy can be enabled in
parallel to the Multiple Networks. To enable the Multiple
Networks option, set the MULTIPLE_SERVICES flag to YES
On RMX 1500, when the MULTIPLE_SERVICES flag is set to YES (Multiple
Networks option is enabled), the LAN_REDUNDANCY flag must be set to NO.
4
If required, reset the RMX. On RMX 2000 reset is required when
adding the RMX2000_RTM_LAN flag.
When LAN Redundancy is enabled on the RMX, LAN 2 port is Active and
LED indications may appear.
The redundant LAN port is shown as Inactive and the LED indications on
the port are switched off.
When the Active LAN port fails and the redundant (Inactive) port takes
over, the LED indications appear.
In the Hardware Monitor pane the Lan List displays the RMX LAN ports
together with their Status indication.
Table 14-18 RMX 1500/2000 /4000 RTM LAN LED Indications
Status
Active
Description
The LAN port is active