Media Encryption; Media Encryption Guidelines - Polycom RMX 1500 Administrator's Manual

Hide thumbs Also See for RMX 1500:
Table of Contents

Advertisement

Polycom RMX 1500/2000/4000 Getting Started Guide

Media Encryption

Media Encryption Guidelines

2-66
Encryption is available at the conference and participant levels, based on
AES 128 (Advanced Encryption Standard) and is fully H.233/H.234
compliant and the Encryption Key exchange DH 1024-bit (Diffie-
Hellman) standards.
Encryption is not available in all countries and it is enabled in the
MCU license. Contact Polycom Support to enable it.
Endpoints must support both AES 128 encryption and DH 1024 key
exchange standards which are compliant with H.235 (H.323) to
encrypt and to join an encrypted conference.
The encryption mode of the endpoints is not automatically
recognized, therefore the encryption mode must be set for the
conference or the participants (when defined).
Media Encryption for ISDN/PSTN participants is implemented in RMX
systems with MPM+ and MPMx cards.
Conference level encryption must be set in the Profile, and cannot be
changed once the conference is running.
If an endpoint connected to an encrypted conference stops encrypting
its media it is disconnected from the conference.
Mixing encrypted and non-encrypted endpoints in one conference is
possible, based on system flag settings:
(ALLOW_NON_ENCRYPT_PARTY_IN_ENCRYPT_CONF).
The behavior is different for H.323/SIP and ISDN participants.
In Cascaded conferences, the link between the cascaded conferences
must be encrypted in order to encrypt the conferences.
Media Encryption for ISDN/PSTN (H.320) participants is not
supported in cascaded conferences.
The recording link can be encrypted when recording from an
encrypted conference to the RSS that is set to encryption. For more
details, see "Recording Link Encryption" on page 12-8.
Encryption of SIP Media is supported using SRTP (Secured Real-time
Transport Protocol) and the AES key exchange method.
Encryption of SIP Media requires the encryption of SIP signaling -
TLS Transport Layer must be used.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rmx 4000Rmx 2000

Table of Contents