Setting A Network Service As Default - Polycom RMX 1500 Administrator's Manual

Polycom RMX 1500/2000/4000 Getting Started Guide
14-80
18 Click the OK button.
The new Network Service is added to the IP Network Services list
pane.

Setting a Network Service as Default

The default Network Service is used when no Network Service is selected
for the following:
• Dial out participants
• Reserving resources for participants when starting an ongoing
conference
• Gateway calls
In addition, the Signaling Host IP address and the MCU Prefix in GK
displayed on the RMX Web Client main screen are taken from the default
H.323 Network Service.
One IP Network Service can be defined as default for H.323 connections
and another Network Service as default for SIP connections. If the IP
Network Service supports both H.323 and SIP connections, you can set
the same Network Service as default for both H.323 and SIP, or for H.323-
only or for SIP-only.
To designate an IP Network Service as the default IP Network Service:
1 In the Device Management pane, click IP Network Services (
2
In the Network Services list pane right-click the IP Network Service to
be set as the default, and then click Set As H.323 Default, or Set As
SIP Default.
The next time you access this menu, a check mark is added next to the
network service type to indicate its selection as default.
To set this IP Network Service for both H.323 and SIP connections,
repeat step 2 and select the option you need.
The following icons are used to indicate the default IP Network
Service type:
Table 14-35 Default IP Network Service Icons
Icon Description
This Network Service supports both SIP and H.323
connections and is designated as default for both SIP
and H.323 connections.
).