Polycom RMX 1500 Administrator's Manual page 819

7
Select the Run all Tests box and then click Run Selected Tests.
Table 20-19 Tests Selection - Additional Test Parameters
Parameter
Loop Test
Stop On Failure
Run All Test
8
The selected tests are initialized. In the Tests Monitoring pane there is
an indication of the Status of the Tests.
9 This process may take some time. Click Stop Running Test to end all
the diagnostic tests. The MCU completes the current test running and
then stops all remaining tests.
10 When the Test are completed, you have the option to download a
report in Excel format for analysis by your next level of support by
clicking the Export Diagnostics Result button.
11 The Diagnostics Mode can be exited by pressing the red System Reset
icon.
12 The RMX then resets.
Chapter 20-RMX Hardware Monitoring
Description
Enter the amount of times the test is to repeat itself
in succession.
Stops tests upon a failure.
Runs all tests listed in the TestActive column for the
hardware component.
20-37