Connected Participant Parameters - Polycom RMX 1500 Administrator's Manual

Polycom RMX 1500/2000/4000 Getting Started Guide

Connected Participant Parameters

Dialing to Polycom® DMA™ 7000
17-26
• The Gateway Profile display name. For example,
Default_GW_Session
• (number) where the number is a gateway conference counter.
For example: if the Gateway Profile display name is Default_GW_Session,
the conference name will be GW_Default_GW_Session(001).
Conference ID:
The ID of the new conference is assigned randomly by the MCU.
The Gateway Session automatically ends when only one participant is left
in the session.
Once this conference is created, the calling participant is connected to it
and one or several dial-out participant(s) are automatically created and
added to this gateway session. The dial-in participant is also identified as
the chairperson of the conference.
The connecting (dial-in) participant name is taken from the endpoint. If
the endpoint does not send its name, it is derived from the Gateway
Profile display name and it includes the Gateway Session name, underscore
and a random number is displayed (between brackets), for example,
GW_Default_GW_Session(001)_(000).
The name of the destination (dial-out) participant is taken from the
endpoint. If the endpoint does not send its name, it is taken from the
dialed number. If the dialed number was an IP address, the system
displays underscores instead of dots, for example, 172_22_172_89.
Participants connected to a gateway session are monitored in the same way
as participants connected to ongoing conferences. For details, see RMX
1500/2000/4000 Administrator's Guide, "Participant Level Monitoring" on
page 11-17.
Two dialing methods are available to ISDN/PSTN participants calling the
DMA:
• Direct with automatically generated destination dial strings from
dial-in strings. This option is available only from version 7.1 and only
to RMX with MPM+ and MPMx cards.