Upgrading To Version 7.2.X And Multiple Services - Polycom RMX 1500 Administrator's Manual

Polycom RMX 1500/2000/4000 Getting Started Guide
Upgrading to Version
14-64
2
Hardware Installation and Setup
— Mount the RMX in a rack. For more details see the
2000/4000 Getting Started Guide, "Hardware Installation and Setup"
on page 2-11.
— Connect the necessary cables. For details, see
Installation"
3
First Entry Power-up and Configuration
— Power up the RMX. For more details see the
4000 Getting Started Guide, "Procedure 1: First-time Power-up"
page 2-22.
— Register the RMX. For more details see the
Getting Started Guide, "Procedure 2: Product Registration"
page 2-23.
— Connect to the RMX. For more details see the
4000 Getting Started Guide, "Procedure 3: Connection to MCU"
page 2-24.
— Configure the Default IP Network Service using the information
for one of the networks connected a media card installed in the
system. For more details see the
Started Guide, "Procedure 4: Modifying the Default IP Service and
ISDN/PSTN Network Service Settings"
— Optional. Configure the ISDN/PSTN Network Service. For more
details see the
4 Modify the required System Flag to enable Multiple Services and
reset the MCU.
5
Add the required IP Network Services to accommodate the networks
connected to the RMX unit.
6
Select a Network Service to act as default for dial out and gateway
calls for which the Network Service was not selected.
7
Place several calls and run conferences to ensure that the system is
configured correctly.
7.2.x and Multiple Services
1
Gather Network Equipment and Address Information for each of the
networks that will be connected to the RMX unit. For a list of
required address, see
Information - IP Network Services Required Information"
on page 67.
RMX 1500/2000/4000 Getting Started Guide.
"Gather Network Equipment and Address
RMX 1500/
"RMX Hardware
RMX 1500/2000/
RMX 1500/2000/4000
RMX 1500/2000/
RMX 1500/2000/4000 Getting
on page 2-26.
on page
on
on
on
14-66.