NEC Univerge SV8100 Features And Specifications Manual page 732

Issue 12.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
15-07-01 Programmable Function Keys
80-01-01 Service Tone Setup – Repeat
Count
80-01-02 Service Tone Setup – Basic Tone
Number
2 - 702
Description/Comments
Assign a function key for Handset
Transmission Cut Off (code 40).
Customize the system basic tones
and system service tones. The
system must be reset for the
changes to take effect.
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the
system must be reset for the
changes to take effect.
Call Screening

Call Holding

Busy Greeting

Await Answer Transfer

UNIVERGE SV8100
Assigned Data
1
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
 
00 ~ 99
(Appearance Function
Code) (Service Code
752 by default)
Refer to Table 2-33
Service Tone Setup
Defaults, Program
80-01-01 on page
2-703.
1~33
(0 = No Tone)
(33=Default Time Slot)
Refer to Table 2-34
Service Tone Setup,
Program 80-01-02 on
page 2-707.
Handset Mute
Level
2 3


