NEC Univerge SV8100 Features And Specifications Manual page 788

Issue 12.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
20-18-02 Service Tone Timers – Busy
Tone Timer
80-01-01 Service Tone Setup – Repeat
Count
80-01-02 Service Tone Setup – Basic Tone
Number
Operation
None
2 - 758
Description/Comments
After getting Intercom dial tone, a
telephone user has this time to dial
the first digit of the Intercom call.
Customize the system basic tones
and system service tones. The
system must be reset for the
changes to take affect.
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the
system must be reset for the
changes to take effect.
Call Screening

Call Holding

Busy Greeting

Await Answer Transfer

UNIVERGE SV8100
Assigned Data
1
0~64800 (seconds)
(default = 15)
0~255 (0 = until
On-Hook)
Refer to Table 2-33
Service Tone Setup
Defaults, Program
80-01-01 on page
2-703
1~33
0 = No Tone
33=Default Time Slot
(Default varies
depending on tone
number. Refer to
SV8100 Programming
manual for more
descriptions)
Howler Tone Service
Level
2 3


