NEC Univerge SV8100 Features And Specifications Manual page 741

UNIVERGE SV8100
Program
Program Name
Number
15-02-16 Multiline Telephone Basic Data
Setup – Handsfree Operation
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
20-06-01 Class of Service for Extensions
20-09-05 Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Operation
To talk Handsfree:
1. Press Speaker, Trunk Line key or Virtual Extension key.
2. Place the call.
3. Speak toward the telephone when the called party answers.
To change a handset call to a Handsfree call:
1. Press Speaker and hang up the handset.
2. Press Speaker again to hang up.
To change a Handsfree call to a handset call:
1. Lift the handset.
Handsfree and Monitor
Description/Comments
Enable/Disable an extension user
ability to use the speakerphone on
outside calls. When disabled, the
user can hear the conversion, but
cannot respond handsfree.
Enable/Disable Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
Assign Class of Service (1~15) for
extensions.
Turn Off or On an extension user
ability to enable Handsfree
Answerback or Forced Intercom
Ringing for their incoming
Intercom calls.
Assigned Data
1
0 = Disable
1 = Enable
(default = 1)
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension
ports = Class 1
0 = Off
1 = On
(default = 1 for COS
1~15)
Issue 12.0
Level
2 3




2 - 711