NEC Univerge SV8100 Features And Specifications Manual page 744

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Issue 12.0
Related Features
Handsfree and Monitor
Microphone Cutoff
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-11-15
Service Code Setup (for Setup/
Entry Operation) – Enable
Handsfree Incoming Intercom
Calls
11-11-16
Service Code Setup (for Setup/
Entry Operation) – Force Ringing
of Incoming Intercom Calls
11-12-06
Service Code Setup (for Service
Access) – Switching of Voice
Call and Signal Call
15-02-16
Multiline Telephone Basic Data
Setup – Handsfree Operation
20-02-12
System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
2 - 714
Description/Comments
If required, change the service
code used for setting an extension
to voice announce for incoming
ICM calls.
If required, change the service
code used for setting an extension
to forced ringing for incoming ICM
calls.
If required, change the service
code used for toggling an outgoing
ICM call between a voice call and
signal call.
Enable/Disable an extension user
ability to use the speakerphone on
outside calls. When disabled, the
user can hear the conversion, but
cannot respond handsfree.
Enable/Disable Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
Handsfree Answerback/Forced Intercom Ringing
UNIVERGE SV8100
Assigned Data
1
MLT
(default = 721)
MLT
(default = 723)
MLT, SLT
(default = 712)
0 = Disable
1 = Enable
(default = 1)
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
Level
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents