Tailgate Glass Components Removal - Hyundai Tiburon 2003 Workshop Manual

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > tailgate glass > Repair
procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > tailgate
glass > Repair procedures
REMOVAL
1. To remove the tailgate glass, first remove the following parts:
(1) Rear window defogger wire connector.
(2) Tailgate trims.
(3) Rear wiper and wiper motor.
2. Remove the tailgate glass in the same manner as the windshield glass.
INSTALLATION
1. Using a cutter knife or the special tool (09861-31200), scrape the old sealant smoothly to a thickness of about
2 mm (0.08 in.) on the bondingsurface around the entire tailgate glass.
Be careful not to remove more adhesive than necessary, and also not to damage the paintwork on the
body surface with the knife. If the paintwork is damaged, repair the damaged area with touch-uppaint.
2. Clean the body bonding surface with a sponge dampened in alcohol or wax and grease remover.
3. Center a new tailgate glass in the opening. Mark the location by marking lines across the glass and body with
a grease pencil at the four pointsas shown.
4. Install the tailgate glass molding without any gaps.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 1 of 3
24.04.2008