Oil Pressure Warning Lamp; Brake Fluid Level Warning Switch; Brake Fluid Level Warning Lamp - Hyundai Tiburon 2003 Workshop Manual

Hide thumbs Also See for Tiburon 2003:

Table of Contents

1. Using an ohmmeter, measure the resistance between the terminal 2 and ground.

2. If the resistance value is not as shown in the table, replace the temperature sender.

Temperature(° C)

Resistance ( )

OIL PRESSURE SWITCH

1. Check that there is continuity between the switch's terminal and ground with the engine stopped.

2. Check that there is no continuity between the terminal and ground with the engine running.

3. If operation is not as specified, replace the switch.

OIL PRESSURE WARNING LAMP

1. Disconnect the connector from the warning switch and ground the terminal on the wire harness side

2. Turn the ignition switch ON. Check that the warning lamp lights up. If the warning lamp doesn't light, test the

bulb or inspect wire harness.

1. Remove the connector from the switch located at the brake fluid reservoir.

2. Verify that continuity exists between switch terminals 1 and 2 while pressing down the switch (float) with a rod.

http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...

Show Quick Links

Table of Contents