Hyundai Tiburon 2003 Workshop Manual page 434

Oil temperature (° C)
3. VEHICLE SPEED SENSOR CHECK
(1) Remove the vehicle speed sensor and connect a 3~10 K resistance as shown in the illustration.
(2) Turn the shaft of the vehicle speed sensor and check that there is voltage between terminals 2-3 (1 turn=4 pulses).
4. A/T CONTROL RELAY CHECK
(1) Remove the A/T control relay.
(2) Use jumper wires to connect A/T control relay terminal 2 to the battery (+) terminal and terminal 4 to the battery (-)
terminal.
(3) Check the continuity between terminal 1 and terminal 3 of the A/T control relay when the jumper wires are
connected and disconnected from the battery.
(4) If there is a problem, replace the A/T control relay.
Jumper wire
Connected
Disconnected
5. SOLENOID VALVE CHECK
(1) Remove the valve body cover.
(2) Disconnect the connectors of each solenoid valve.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
0
100
Resistance (K )
16.7 ~ 20.5
0.57 ~ 0.69
Continuity between terminal No.1
Continuity
No continuity
Page 9 of 13
24.04.2008