Hyundai Tiburon 2003 Workshop Manual page 462

3. Apply multipurpose grease to the clutch release lever fulcrum contact surface of the clutch release fork
assembly.
CASMOLY L9508
4. Clean the surfaces of the flywheel and pressure plate thoroughly with fine sandpaper or crocus cloth, and
make certain that all oil or grease has been removed.
5. Apply a small amount of multipurpose grease to the clutch disc splines and input shaft splines.
CASMOLY L9508
Do not apply more grease than necessary. Too much grease could cause clutch slip or judder.
6. Using the special tool (09411-25000), install the clutch disc to the flywheel. When installing the clutch disc, be
sure that the surface having the manufactures stamp is towards the pressure plate side.
7. Install the the clutch cover assembly onto the flywheel and install the six (6) bolts through the clutch cover into
the flywheel.
8. Tighten the bolts by one or two turns at a time, in succession, to avoid bending the cover flange.
If a special tool is not available, tighten the bolt temporarily and then torque to specification in diagonal
torquing sequence indicated below.
TIGHTENING TORQUE
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 2 of 4
24.04.2008