Clutch Pedal Inspection And Adjustment - Hyundai Tiburon 2003 Workshop Manual

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Clutch System > Clutch System > The Other Clutch System
Component > Repair procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Clutch System > Clutch
System > The Other Clutch System Component > Repair procedures
SERVICE ADJUSTMENT PROCEDURE

CLUTCH PEDAL INSPECTION AND ADJUSTMENT

1. Measure the clutch pedal height (from the face of the pedal pad to the floorboard) and the clutch pedal clevis
pin play (measured at the face of the pedal pad).
(A) 166.9 mm
2. If the clutch pedal clevis pin free-play is not within the standard value range, adjust as follows:
A. Turn and adjust the bolt, then secure by tightening the lock nut.
After the adjustment, tighten the bolt until it reaches the pedal stopper, and then tighten the lock nut.
• Turn the push rod to agree with the standard value and then secure the push rod with the lock nut.
When adjusting the clutch pedal height or the clutch pedal clevis pin play, be careful not to push the
push rod towardthe master cylinder.
3. After completing the adjustments, check that the clutch pedal free play (measured at the face of the pedal
pad) is within the standard value ranges.
Standard value:
(B) 6~13 mm (0.24~0.52 in.)
(C) 50 mm (1.5 in.)
4. If the clutch pedal free play, and the distance between the clutch pedal and the floor board when the clutch is
disengaged, do not meet with the standard values, it may be the result of either air in the hydraulic system or
a faulty clutch master cylinder. Bleed the air or disassemble and inspect the master cylinder or clutch.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 1 of 2
24.04.2008