C. Turn the ignition switch to LOCK, and wait for 30 seconds.
D. Turn the ignition switch to ON, and wait for 30 seconds.
E. Using the Hi-Scan Pro, check for DTCs.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this procedure.
9. Check the PAB squib.
[PREPARATION]
A. Turn the ignition switch to LOCK.
B. Disconnect the negative (-) terminal cable from the battery, and wait for 30 seconds.
C. Connect the PAB connector.
D. Connect the negative (-) terminal cable from the battery, and wait for 30 seconds.
[CHECK]
A. Turn the ignition switch to ON, and wait for at least 30 seconds.
B. Clear the malfunction code stored in the memory with the Hi-Scan Pro.
C. Turn the ignition switch to LOCK, and wait for 30 seconds.
D. Turn the ignition switch ON, and wait for 30 seconds.
E. Using the Hi-Sacn Pro, check for DTCs.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this procedure.
10. Check the SAB squib.
[PREPARATION]
A. Turn the ignition switch to LOCK.
B. Disconnect the negative (-) terminal cable from the battery, and wait for 30 seconds.
C. Connect the SAB connector.
D. Connect the negative (-) terminal cable from the battery, and wait for 30 seconds.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 15 of 34
24.04.2008