Hyundai Tiburon 2003 Workshop Manual page 656

[CHECK]
Measure the resistance between the PAB high (+) and the PAB low (-).
1.6 ≤ R ≤ 2.8
3. Check the PAB squib.
[PREPARATION]
A. Turn the ignition switch to LOCK.
B. Disconnect the negative (-) terminal cable from the battery, and wait for 30 seconds.
C. Connect the PAB connector.
D. Connect the negative (-) terminal cable to the battery, and wait for 30 seconds.
[CHECK]
A. Turn the ignition switch to ON, and wait for at least 30 seconds.
B. Clear the malfunction code stored in the memory with the Hi-Scan Pro.
C. Turn the ignition switch to LOCK, and wait for 30 seconds.
D. Turn the ignition switch to ON, and wait for 30 seconds.
E. Using Hi-Scan Pro, check the DTC.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this procedure.
CIRCUIT INSPECTION
DTC
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
B1378 DSAB Resistance too high (R ≥ 5.4
B1379 DSAB Resistance too low (R ≤ 0.4
B1382 PSAB Resistance too high (R ≥ 5.4
B1383 PSAB Resistance too low (R ≤ 0.4
Page 22 of 34
)
)
)
)
24.04.2008