Table of Contents
Advertisement
15. Tighten the feed tube to the specified torque and install the mounting rubber using adhesive.
16. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
Silicone grease
17. Install the new attaching band to the bellows.
When the bellows are installed, a new band must be used.
18. Install the bellows in position, taking care not to twist it.
19. Fill the dust cover inner side and lip with the specified grease, and fix the dust cover in position with the clip
ring attached in the grooveof the tie rod end.
Recommended grease
A : POLY LUB GLY 801K or equivalent
B : SHOWA SUNLIGHT MB2 or equivalent
Dust cover inner side and lip : THREE BOND
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 12 of 14
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
