Hyundai Tiburon 2003 Workshop Manual page 18

7. Loose connectors cause problems. Make sure that the connectors are always securely fastened.
8. When disconnecting a connector, be sure to grip only the connector, not the wires.
9. Disconnect connector which have catches by pressing in the direction of the arrows shown in the illustration.
10. Connect connectors which have catches by inserting the connectors until they make a clicking sound.
11. When using a circuit tester to check continuity or voltage on connector terminals, insert the test probe into the harness side. If the
connector is a sealed connector, insert the test probe through the hole in the rubber cap until contacts the terminal, being careful
not to damage the insulation of the wires.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 18 of 20
24.04.2008