Hyundai Tiburon 2003 Workshop Manual page 742

9. Scrape or wipe excess adhesive off with putty knife or gauze. Fill all cavities around the tailgate glass.
10. Perform a water-leak test for the tailgate glass. Use a cold water spray, being careful not to direct a powerful
stream of water on the new adhesivematerial. Allow water to spill over the edges of the glass.
11. If there are leaks, dry the affected area, then apply sealant.
12. Install the removed parts.
1. Keep the tailgate glass dry for the first hour after installation.
2. Let the car stand for at least four hours after tailgate glass installation. If the car has to be used
winthin the first 8 hours, it mustbe driven slowly.
3. Take care not to slam the doors with all the windows rolled up.
4. Take care not to twist the vehicle excessively (such as when going in and out of driveways at an
angle or driving over rough, uneven roads).
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 3 of 3
24.04.2008