Hyundai Tiburon 2003 Workshop Manual page 813

Time specification
T1 : 0.5 sec.
T2 : 1.0±0.2 sec.
(2) New alarm conditions
Second alarm condition during alarming.
When another alarm occurs during alarming, the starting is disabled, and the alarm continues to sound for
the remained time of warning signal. The alarm continues to sound after the second alarm condition is
removed.
New alarm condition occurs after alarming (with all entrances closed)
If any entrance is opened again then
A. The horn is ON 3 times (EC area : one time for 27sec.)
B. Start is disabled
C. Hazard lamps flash during the ON time of horn
New alarm condition occur after alarming (with any entrance open).
If another entrance is opened, the BCM keeps start disabled and there is no horn output.
(3) Key operation during alarm
After the alarm state or start inhibit state are entered, if door warning switch on (key in ignition) & IGN 2
ON, if IGN 2 state is changed to OFFwithin 30sec, remain in alarm state.
(4) Disarming using the key
During alarming, in case that door warning switch (key in) is ON and then IGN1 and IGN2 are both ON for
30 sec continuously, the alarm is cancelled,and the system enters the disarm state.
After alarming, in case that door warning switch (key in) is ON and then IGN1 and IGN2 are both ON for
30 sec continuously, the alarm is cancelled,and the system enters the disarm state.
5. Alarm state in power down
If the battery is disconnected to the BCM in the following states:
A. Alarm
B. After alarming
Upon restoring the battery, the alarm state shall be entered and the alarm cycle shall restarted (timer reset to
0).
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 10 of 11
24.04.2008