Table of Contents
Advertisement
Remove the field coil(A) from the shaft with a puller(B). Be careful not to damage the coil and compressor.
5. Reassemble the compressor clutch in the reverse order of disassembly, and note these items :
A. Install the field coil with the wire side facing down, and align the boss on the coil with the hole in the
compressor.
B. Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
C. Install new snap rings, and make sure they are fully seated in the groove.
D. Make sure that the pulley turns smoothly after it's reassembled.
E. Route and clamp the wires properly or they can be damaged by the pulley.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 4 of 4
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
