Hyundai Tiburon 2003 Workshop Manual page 664

[CHECK]
Check the resistance with the switch on and off.
SWITCH OPEN : R = 4K
SWITCH OPEN : R = 1K
CIRCUIT INSPECTION
DTC
CIRCUIT DESCRIPTION
INSPECTION PROCEDURE
1. Check the fuse.
[PREPARATION]
A. Remove airbag fuse and airbag warning lamp fuse from the junction block.
B. Inspect the state of the fuses.
C. Replace if necessary.
2. Check the SRS warning lamp circuit.
[PREPARATION]
A. Connect the negative (-) terminal cable to the battery.
B. Turn the ignition switch to ON.
[CHECK]
A. Measure voltage at the harness side connector of the SRSCM.
Voltage : 9-16 V
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
± 10% (Belted)
± 10% (Unbelted)
B2500
Page 30 of 34
Warning lamp failure
24.04.2008