Table of Contents
Advertisement
TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Brake System > Brake System > Brake Pedal > Repair
procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Brake System > Brake System > Brake Pedal >
Repair procedures
REMOVAL
1. Remove the stop lamp switch.
2. Remove the split pin and clevis pin.
3. Remove the flange nuts of the brake mounting bracket.
4. Remove the brake pedal assembly.
INSTALLATION
1. Installation is the reverse of removal.
Be sure to install the split pin on the operating rod clevis pin.
2. Install the brake pedal assembly and tighten the flange nuts (booster mounting nuts) and bolt.
Tightening torque:
13~16 Nm (130~160 kgf·cm, 6~9 lbf·ft)
3. Adjust the brake pedal height and free play.
4. Install the stop lamp switch.
INSPECTION
1. Check the bushing for wear.
2. Check the brake pedal for distortion.
3. Check the brake pedal return spring for damage.
4. Check the stop lamp switch.
(1) With an ohmmeter connected to the stop lamp switch terminals, check for continuity.
(2) If there is no continuity when the plunger is depressed and there is continuity when the plunger is
released, the stop lamp switch is normal.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 1 of 2
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
