Tailgate Glass Removal; Tailgate Glass Installation - Hyundai trajet Shop Manual

INTERIOR
SD -35
TAILGATE GLASS
REMOVAL
ESHA1450
1. To remove the tailgate glass, first remove the follow-
ing parts:
1) Rear window defogger wire connector.
2) Tailgate trims.
'/LL~--
09861-31200
ESDA235B
ESHA055B
/
--~--t-!!l---_
- - -
3. Center a new tailgate glass in the opening. Mark the
location by marking lines across the glass and body
with a grease pencil at the four points as shown.
ESHA150B
4. Glue the rubber dam to the inside surface of the
tailgate glass around the entire edge as shown, to
contain the sealant during installation.
2. Clean the body bonding surface with a sponge
dampened in alcohol or wax and grease remover.
5. Install the tailgate glass molding without any gaps.
6. Apply a light coat of glass primer to the outside of
the dam.
ESHA055A
-'-;----- Rear wiper
- r - - - -
Rear wiper motor
Tailgate glass
~~
\Ii!
,~p,
.... \,
Tailgate glass
~.'--T",
High mounted stop
,amp4~
Tailgate trim
4) High mounted stop lamp.
3) Rear wiper and wiper motor.
2. Remove the tailgate glass in the same manner as
the windshield glass.
NOTE
INSTALLATION
ESHA1500
1. Using a cutter knife or the special tool, scrape the
old sealant smoothly to a thickness of about 2 mm
(0.08 in.) on the bonding surface around the entire
tailgate glass.
1. Never touch the surface applied primer with your
hands.
If you do, the adhesive may not bond to the glass
properly, causing a leak after the tailgate glass
has been installed.
2. Do not apply body primer to the glass.
3. Keep water, dust, and abrasive materials away
from the surface applied primer.
CAUTION
Be careful not to remove more adhesive than neces-
sary, and also not to damage the paintwork on the
body surface with the knife. If the paintwork is dam-
aged, repair the damaged area with touch-up paint.