Front Driveshaft Installation - Hyundai Tiburon 2003 Workshop Manual

9. Remove the center bearing bracket mounting bolts. Insert the pry bar between the center bearing bracket and
the cylinder block to disconnect thebracket from the cylinder block. (for 2.7L engine)
10. Remove the inner shaft from the center bearing. (for 2.7L engine)
11. Using the special tool (09432-11000), remove the tone wheel.
Before removing the tone wheel, be sure to remove the B.J. assembly side dust cover.
INSTALLATION
1. After installing the birfield joint assembly side tone wheel, install the dust cover, keeping the specified
clearance as below.
2. Apply gear oil on the driveshaft splines and differential case contacting surface.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 2 of 8
24.04.2008