Hyundai Tiburon 2003 Workshop Manual page 17

2. Attach the wiring harnesses with clamps so that there is no slack. However, for any harness which passes the engine or other
vibrating parts of the vehicle, allow some slack within a range that does not allow the engine vibrations to cause the harness to
come into contact with any of the surrounding parts and then secure the harness by using a clamp.
3. If any section of a wiring harness interferes with the edge of a parts, or a corner, wrap the section of the harness with tape or
something similar in order to protect it from damage.
4. When installing any parts, be careful not to pinch or damage any of the wiring harness.
5. Never throw relays, sensors or electrical parts, or expose them to strong shock.
6. The electronic parts used in the computer, relays, etc. are readily damaged by heat. If there is a need for service operations that
may cause the temperature to exceed 80° C (176° F), r emove the electronic parts beforehand.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 17 of 20
24.04.2008