Hyundai Tiburon 2003 Workshop Manual page 641

[CHECK]
A. Turn ignition switch to ON, and wait for at least 30 seconds.
B. Clear any codes stored in the memory with the Hi-Scan Pro.
C. Turn the ignition switch to LOCK, and wait for 30 seconds.
D. Turn the ignition switch to ON, and wait for 30 seconds.
E. Using the Hi-Sacn Pro, check for DTCs.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this check.
8. Check the DAB squib.
[PREPARATION]
A. Turn the ignition switch to LOCK.
B. Disconnect the negative (-) terminal cable from the battery, and wait for 30 seconds.
C. Connect the DAB connector.
D. Connect the negative (-) terminal cable to the battery, and wait for 30 seconds.
[CHECK]
A. Turn the ignition switch to ON, and wait for at least 30 seconds.
B. Clear the malfunction code stored in the memory of the Hi-Scan Pro.
C. Turn the ignition switch to LOCK, and wait for 30 seconds.
D. Turn the ignition switch to ON, and wait for 30 seconds.
E. Using the Hi-Scan Pro, check for DTCs.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this procedure.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 7 of 34
24.04.2008