Table of Contents
Advertisement
3. Install the camshafts after lubricating the journals of the camshaft with engine oil.
To check the press fit, the camshaft (IN) and timing chain sprocket should be separable by a force
greater than 1000kg (MIN.)at room temperature.
4. Install the bearing caps. Check the markings on the caps for intake/exhaust identification symbol.
I : Intake camshaft
E : Exhaust camshaft
5. Tighten the bearing caps to the specified torque in two or three increments as shown.
Tightening torque
Bearing cap bolt
M6 (50mm) : 14 ~ 16Nm (140 ~ 160kg.cm, 10 ~ 12lb.ft)
M6 (38mm) : 10 ~ 12Nm (100 ~ 120kg.cm, 7 ~ 9lb.ft)
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 4 of 6
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
