Abs(Anti-Lock Brake System) System Function - Hyundai Tiburon 2003 Workshop Manual

Hide thumbs Also See for Tiburon 2003:

Table of Contents

3. Turn the ignition switch ON.

4. Check for diagnostic trouble codes using the Hi-scan (pro).

5. After completion of the repair or correction of the problem, erase the stored fault codes using the clear key on the Hi-

6. Disconnect the Hi-scan (pro) from the 16P data link connector.

SYSTEM FUNCTION

ABS OPERATION

1. NORMAL BRAKING

Solenoid valve

Under the normal braking, voltage is not supplied to solenoid valve, inlet valve is opened and outlet valve is closed.

When the brake is depressed, brake fluid is supplied to the wheel cylindervia solenoid valve to activate the brake.

When the brake is released, brake fluid is back to the master cylinder via inlet valve and check valve.

2. DUMP MODE

Solenoid valve

Under the emergency braking, if the wheels start to lock up, HECU sends a signal to the solenoid valve to decrease

the brakefluid, then voltage is supplied to each solenoid. At this time inlet valve is closed and brake fluid is blocked

from the mastercylinder. Conversely outlet valve is opened and brake fluid passes through wheel cylinder to reservoir,

resulting in pressure decrease.

3. HOLD MODE

Solenoid valve

When the brake fluid pressure is maximally decreased in wheel cylinder, HECU sends a signal to solenoid valve to

keep the fluidpressure, voltage is supplied to inlet valve but it is not supplied to outlet valve. At this time inlet and outlet

valves are closed and brake fluid is kept in wheel cylinder.

4. INCREASE MODE

Solenoid valve

http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...

Master cylinder

Wheel cylinder

Master cylinder

Wheel cylinder

Master cylinder

Wheel cylinder

Master cylinder

Wheel cylinder

Show Quick Links

Table of Contents

Troubleshooting