Hyundai Tiburon 2003 Workshop Manual page 651

12. Check the Satellite sensors.
[PREPARATION]
A. Turn ignition switch to LOCK.
B. Disconnect the negative (-) terminal cable from the battery, and wait at least 30 seconds.
C. Connect the Satellite sensor connector.
D. Connect the negative (-) terminal cable from the battery, and wait at least 30 seconds.
[CHECK]
A. Turn the ignition switch to ON, and wait at least 30 seconds.
B. Clear the malfunction code stored in memory with Hi-scan.
C. Turn the ignition switch to LOCK, and wait at least 30 seconds.
D. Turn the ignition switch to ON, and wait at least 30 seconds.
E. Using the Hi-Scan Pro, check for DTCs.
There is no DTC.
[HINT]
Codes other than these may be output at this time, but they are not relevant to this procedure.
13. Check the Clock spring.
[PREPARAION]
A. Turn the ignition switch to LOCK.
B. Disconnect the connector between the SRSCM and the clock spring.
[CHECK]
Turn the ignition switch ON, and measure the voltage between the DAB high side and the body ground.
Voltage : 0V
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 17 of 34
24.04.2008