Hyundai Tiburon 2003 Workshop Manual page 109

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Engine Mechanical System > Engine And Transaxle Assembly
> Engine And Transaxle Assembly > Repair procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC >
Engine Mechanical System > Engine And Transaxle Assembly > Engine And Transaxle Assembly >
Repair procedures
REMOVAL
1. Remove the battery.
2. Detach the air cleaner.
3. Disconnect the engine harness connectors.
A. Engine wiring connectors (alternator, starter, etc.)
B. TPS connector
C. Power steering switch connector, oil pressure gauge connector.
D. Back up lamp switch connector.
E. A/T solenoid, inhibitor switch connector.
F. Coolant temperature sensor.
G. Ignition coil, power TR connector.
H. Idle speed control valve (ISC) connector.
I. MAP and ATS connectors.
J. Oxygen sensor connector.
4. Drain the engine coolant.
5. For a vehicle with automatic transaxles, disconnect the transaxle oil cooler hoses.
When disconnecting hoses, make identification marks to avoid making any mistake when installing them
again.
Be careful not to spill any of oil or fluid out of the hoses. Plug the openings to prevent the entry of foreign
material.
6. Disconnect the radiator upper and lower hoses on the engine side then remove the radiator assembly.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 1 of 5
24.04.2008