Hyundai Tiburon 2003 Workshop Manual page 500

12. Install the tab washer and the tie rod and stake the tab washer end at two points over the tie rod.
13. Install the bushing, rack support yoke, rack support spring and yoke plug in the order shown in the
illustration. Apply semi-drying sealantto the threaded section of the yoke plug before installation.
14. With the rack placed in the center position, attach the yoke plug to the rack housing. Tighten the yoke plug to
12 Nm (120 kg·cm, 8.9 lb·ft), with a 14mm socket. Loosen the yoke plug approximately from 30° to 60° an d
tighten the yoke nut to the specified torque.
Tightening torque
50~70 Nm (500~700 kg·cm, 37~52 lb·ft)
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 11 of 14
24.04.2008