Hyundai Tiburon 2003 Workshop Manual page 107

5. Using the special tool (09222-28000, 09222-28100), compress the spring and install the retainer locks. After
installing the valves, ensure that the retainer locks are correctly in place before releasing the valvespring
compressor.
When the spring is compressed, check that the valve stem seal is not pressed against the bottom of the
retainer.
6. Clean both gasket surfaces of the cylinder head and cylinder block.
7. Verify the identification marks on the cylinder head gasket.
8. Install the gasket so that the surface with the identification mark faces toward the cylinder head.
Do not apply sealant to these surfaces.
9. Tighten the cylinder head bolts in the sequence shown in the illustration with a torque wrench.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 7 of 8
24.04.2008