Hyundai Tiburon 2003 Workshop Manual page 186

Hide thumbs Also See for Tiburon 2003:

Table of Contents

• Camshaft Position Sensor (CMP sensor)

• Evaporative Emission Control System

• Vehicle Speed Sensor (VSS)

• Idle Speed Control

1. After turning the ignition key on, check that the light illuminates for 5 seconds without the engine running.

2. If the light does not illuminate, check for an open circuit in the harness,blown fuse and blown bulb.

• When battery voltage is excessively low, diagnostic trouble codes can not be read. Be sure to check the battery for

voltage and the charging system before starting the test.

• Codes are erased if the battery or the PCM connector is disconnected. Do not disconnect the battery before the

diagnostic trouble codes are completely read and recorded.

1. Turn OFF the ignition switch.

2. Connect the scan tool to the data link connector on the lower crash pad.

3. Turn ON the ignition switch.

4. Use the Hi-Scan Pro to check the diagnostic trouble code.

5. Repair the faulty part from the diagnosis chart.

6. Erase the diagnostic trouble code.

7. Disconnect the Hi-Scan Pro.

TROUBLESHOOTING

DIAGNOSTIC TROUBLESHOOTING FLOW

http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...

Show Quick Links

Table of Contents

Troubleshooting