Table of Contents
Advertisement
2. Remove the glove box.
3. Disconnect the PAB module connector.
4. Remove the crash pad assembly and then undo the PAB module. (Refer to the BD section)
5. The skin of the passenger airbag module is integrated with the crash pad, therefore, the crash pad must be
replaced if the PAB deploys.
INSPECTION
AIRBAG MODULE
Dispose the old one according to the specified procedure.
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the
specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in
serious personal injury.
1. Check pad cover for dents, cracks or deformities.
2. Check the airbag module for denting, cracking or deformation.
3. Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4. Check airbag inflator case for dents, cracks or deformities.
5. Install the airbag module to the steering wheel to check for fit or alignment with the wheel.
CLOCK SPRING
1. If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a
new one.
2. Check connectors and protective tube for damage, and terminals for deformities.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 3 of 4
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
