Table of Contents
Advertisement
4. The roof panel (A) should be even with the glass (B) weatherstrip (C), to within the standard value "E" all the
way around. If not, make the following adjustment.
Standard value "E"
Front edge: 2+0/-1mm (0.08+0/-0.04in.)
Rear edge: 2+1/-0mm (0.08+0.04/-0in.)
5. If the position is not as specified, lightly loosen the glass adjusting screw (A) to adjust the glass height and
tighten it.
Tightening torque: 2~4Nm (20~40kgf·cm, 1.5~2.9 lbf·ft)
6. Check for overlap between the sunroof weatherstrip (A) and the roof panel (B).
Standard value: 1.1 mm
ADJUSTMENT
INITIAL SETTING (GENERAL, OPERATION)
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Page 7 of 8
24.04.2008
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
