Hyundai Tiburon 2003 Workshop Manual page 657

CIRCUIT DESCRIPTION
DTC Detecting Condition
• Too high or low resistane between SAB high (+) wiring
harness and SAB low (-) wiring harness of squib.
• SAB malfunction
• SRSCM malfunction
WIRING DIAGRAM
INSPECTION PROCEDURE
1. Preparation
(1) Disconnect the negative (-) terminal cable from the battery, and wait at least 30 seconds.
(2) Remove the DAB module.
(3) Disconnect the connectors of the PAB, left and right side airbags, belt pretensioners and satellite sensors.
(4) Disconnect the SRSCM connector.
Place the DAB with the front surface facing upward.
2. Check the SAB resistance.
[PREPARATION]
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title...
Trouble Area
• SAB squib
• SRSCM
• Wire harness
Page 23 of 34
24.04.2008