Isuzu 1999 RODEO Workshop Manual page 785

Rodeo 1999
Hide thumbs Also See for 1999 RODEO:
Table of Contents

Advertisement

6E1–158 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
DTC P0135 – O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)
Step
6
1. Allow the HO2S to cool for at least 10 minutes.
2. Using a Digital Voltmeter (DVM), measure the
resistance between the Bank 1 HO2S 1 ignition
feed and the Bank 1 HO2S 1 heater ground at the
Bank 1 HO2S 1 pigtail.
Is the HO2S heater resistance within the specified
values?
7
Repair the open Bank 1 HO2S 1 ignition feed circuit to
Bank 1 HO2S 1.
Is the action complete?
8
Repair the open Bank 1 HO2S 1 heater ground circuit
to Bank 1 HO2S 1.
Is the action complete?
9
1. Check for a poor connection at the Bank 1 HO2S 1
harness terminals.
2. If a poor connection is found, replace terminals.
Was a poor connection found?
10
Check for a poor Bank 1 HO2S 1 high or low circuit
terminal connection at the Bank 1 HO2S 1 harness
connector and replace terminal(s) if necessary.
Did any terminals require replacement?
11
1. Ignition OFF.
2. Disconnect the PCM and check the continuity of the
Bank 1 HO2S 1 signal circuit and the Bank 1 HO2S
1 low circuit.
3. If the Bank 1 HO2S 1 high circuit or HO2S low circuit
measures over 5 W, repair open or poor connection
as necessary.
Was a problem found?
12
Check for a poor Bank 1 HO2S 1 low circuit terminal
connection at the PCM and replace the terminal if
necessary.
Did the terminal require replacement?
13
Check for a poor Bank 1 HO2S 1 high circuit terminal
connection at the PCM and replace the terminal if
necessary.
Did the terminal require replacement?
14
Replace the Bank 1 HO2S 1.
Is the action complete?
15
Locate and repair the short to ground in Bank 1 HO2S 1
ignition feed circuit and replace the fault fuse.
Is the action complete?
(Cont'd)
Action
Value(s)
Yes
3–6 ohms
Go to Step 9
Verify repair
Verify repair
Verify repair
Verify repair
Verify repair
Verify repair
Verify repair
Verify repair
Verify repair
No
Go to Step 10
Go to Step 10
Go to Step 11
Go to Step 12
Go to Step 13
Go to Step 14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents