Isuzu 1999 RODEO Workshop Manual page 1129

6A–44 ENGINE MECHANICAL (6VD1 3.2L)
f Apply engine oil to oil seal lip.
f Install oil pump in the cylinder block and tighten
fixing bolts to the specified torque.
Torque : 25 N·m (18 lb ft)
Legend
(1) Around Bolt Holes
(2) Around Dowel Pin
9. Install oil strainer with O-ring, tighten to the specified
torque.
Torque : 25 N·m (18 lb ft)
10. Install oil pipe with O-ring, tighten fixing bolts to the
specified torque.
Torque : 25 N·m (18 lb ft)
11. Install crankcase.
f Remove oil on crankcase mounting surface and dry
the surface.
f Properly apply a 4.5 mm (0.7 in) wide bead of
sealant (TB1207C or equivalent) to the crankcase
mounting surface. The bead must be continuous.
f The crankcase must be installed within 5 minutes
after sealant application to prevent premature
hardening of sealant.
f Tighten fixing bolts to the specified torque.
Torque : 10 N·m (89 lb in)
051RW002
051RW001
12. Install oil pan
f Remove oil on oil pan mounting surface and dry the
surface.
f Properly apply a 4.5 mm (0.7 in) wide bead of
sealant (TB1207C or equivalent) to the oil pan
mounting surface. The bead must be continuous.
f The oil pan must be installed within 5 minutes after
sealant application to prevent premature hardening
of sealant.
013RW010
013RW004