Isuzu 1999 RODEO Workshop Manual page 1158

f Carefully mount the crankshaft.
f Apply engine oil to the thrust washer.
f Assemble the thrust washer to the No.3 bearing
journal. The oil grooves must face the crankshaft.
2. Rear oil seal (10)
f Remove the oil from the cylinder block and the
retainer mounting surface.
f Apply sealant (TB–1207B or equivalent) to the
retainer mounting surface, following the pattern
shown in the illustration.
The retainer must be installed within 5 minutes after
sealant application to prevent premature hardening
of sealant.
Legend
(1) Around Bolt Holes
(2) Around Dowel Pin
ENGINE MECHANICAL (6VD1 3.2L)
f Apply engine oil to the oil seal lip.
f Align the cylinder block dowel pin holes with the rear
retainer dowel pins.
f Tighten the rear retainer fixing bolts. New bolts
should be used when installing rear retainer.
Torque: 18 N·m (13 lb ft)
NOTE: Be very careful not to disengage the oil seal garter
spring during installation of the rear retainer.
If the seal was removed from retainer for
replacement, apply engine oil to the oil seal lip and
install the oil seal using J–39201 oil seal installer.
015RS013
3. Flywheel (9)
015RW002 1. Thoroughly clean and remove the oil from the
threads of crankshaft.
2. Remove the oil from the crankshaft and flywheel
mounting faces.
3. Mount the flywheel on the crankshaft and then
install the washer.
6A–73
015RW001
015RS017