Isuzu 1999 RODEO Workshop Manual page 1159

6A–74 ENGINE MECHANICAL (6VD1 3.2L)
4. Hold the crankshaft to prevent from rotating then
install the bolts in the order shown to the specified
torque.
Torque: 54 N·m (40 lb ft)
NOTE: Do not reuse the bolt and do not apply oil or thread
lock to the bolt.
4. Piston and connecting rod assembly (8)
f Apply engine oil to the cylinder bores, the
connecting rod bearings and the crankshaft pins.
Check to see that the piston ring end gaps are
correctly positioned.
Legend
(1) No.1 Compression Ring
(2) No.2 Compression Ring
(3) Oil Ring Side Rail Upper
(4) Oil Ring Side Rail Lower
(5) Piston Front Mark
f Insert the piston/connecting rod assemblies into
each cylinder with the piston ring compressor. The
front marks must be facing the front of the engine.
f Match the numbered caps with the numbers on the
connecting rods. Align the punched marks on the
connecting rods and caps.
f Apply engine oil to the threads and seating faces of
the nuts.
f Tighten the nuts.
Torque: 54 N·m (40 lb ft)
After tightening the cap nuts, check to see that the
crankshaft rotates smoothly.
NOTE: Do not apply engine oil to the bearing back faces.
015RS018
5. Install oil gallery (7) and tighten the bolts in 2 steps, in
the order shown.
1st step: 29 N·m (22 lb ft)
2nd step: 55°∼ 65°
015RS019
015RS020
051RS009