Reassembly - Isuzu 1999 RODEO Workshop Manual

Reassembly

1. Install Spark plug and tighten all the spark plugs to
specified torque.
Torque: 18 N·m (13 lb ft)
2. Tighten sub gear setting bolt.
1. Use J–42686 gear spring lever to turn sub gear to
right direction until the M5 bolt aligns with the hole
between camshaft driven gear and sub gear.
2. Tighten the M5 bolt to a suitable torque to prevent
the sub gear from moving.
3. Install camshaft drive gear assembly and tighten
three bolts to the specified torque.
Torque: 10 N·m (89 lb in)
4. Install camshaft assembly and camshaft brackets,
tighten twenty bolts on one side bank to the specified
torque.
1. Apply engine oil to camshaft journal and bearing
surface of camshaft bracket.
2. Align timing mark on intake camshaft (one dot for
right bank, two dots for left bank) and exhaust
camshaft (one dot for right bank, two dots for left
bank) to timing mark on camshaft drive gear (one
dot).
ENGINE MECHANICAL (6VD1 3.2L)
Legend
(1) Intake Camshaft Timing Gear for Right Bank
(2) Intake Camshaft Timing Gear for Left Bank
(3) Exhaust Camshaft Timing Gear
(4) Discrimination Mark
LI: Left Bank Intake
RI: Right Bank Intake
LE: Left Bank Exhaust
RE: Right Bank Exhaust
014RW025
Legend
(1) Right Bank Camshaft Drive Gear
(2) Left Bank Camshaft Drive Gear
(3) Timing Mark on Drive Gear
(4) Dowel Pin
6A–53
014RW020
014RW023