Removal - Isuzu 1999 RODEO Workshop Manual

Removal

1. Disconnect battery ground cable
2. Wiring connector from crankshaft angle sensor.
3. Remove crankshaft angle sensor from cylinder block.
Installation
1. Install crankshaft angle sensor into the cylinder block.
Before installation,apply small amount of engine oil to
the O–ring.
Torque: 10 N·m (89 lb in)
2. Reconnect wiring connector to crankshaft angle
sensor.
Crankshaft Angle Sensor
012RS008
IGNITION SYSTEM (6VD1 3.2L) 6D2–5